Adriel Lift Top Four Leg Coffee Table with Storage

Looks very nice once assembled however there were a few issues in the quality of manufacturing. Some of the holes that were for the Q fittings were drilled with the wrong diameter. Just a bit too small to get the entire plastic shaft of the Q fitting all the way in. I was able to trim some of the plastic off to help but it was still difficult in some cases to get fitting R to turn fully as a result. The main issue however was with panel C and trying to line it up with the assembly in stage 8 page 7. No matter what I did it just would not line up. I then realized that the holes for the centre panel were drilled in the wrong place for both fitting Q and fitting P. I did manage to get it in at one point but because of the manufacturing fault section E ended up bent like a banana. The only way I could move forward was to remove the Q and P fittings from the middle sections. Then I was able to fit the two parts together. The top panel A moves back quite a bit to open so we have to move the whole thing forward from the wall in order to open it. It does look good however and it is a real shame about the design faults. Just to verify my claims about the faults I am a highly experienced engineer with over 40 years of working on complex systems.

Confusing instructions. Some parts were up when it should be down. Front when it should be back. Some holes were misaligned. I had to improvise.There was one set of screws I didn’t need. I almost gave up.

Nie wieder wayfair! Bohrungen passten nicht, Funier gebrochen, Farbe von den Knöpfen platzt ab.