This custom-made roller blind is reliable sun protection or heat protection for the living room, dining room, kitchen or conservatory. The release of heat from the room to the outside, as well as the heating of the room due to the sun's rays, is reduced. The easy-to-clean material is easily mounted with a clamping carrier system, which fits standard window frame thicknesses the silver-coloured aluminium back with heat and cold-reflecting properties making it possible to darken the living room in an energy-saving way, neither in summer nor in winter. In addition, you can not only darken rooms perfectly at any time but guarantee this roller blind also provides privacy. Thanks to another feature that pays off especially in the bathroom and in the kitchen, you can enjoy its great practicality and ease of use in damp rooms. All highlights at a glance. This roller blind is made from 100% polyester with silver-coloured light stop coating on the back. Selectable seam thicknesses 1-2cm. Window, door, wall mounting set include clamping carrier without drilling, screw set for drilling as an alternative how to measure correctly. On the window frame, measure from the middle of the frame on the left to the middle of the frame on the right, this results in the order width. Please make sure to check whether the fabric can run past the window handle. In order to cover the pane completely, however, the width should be at least 4cm wider than the pane. In front of the window niche, first, measure the niche width. To cover the entire window niche, order a roller blind that is approximately 20cm wider. The height can be measured from the ceiling to the window sill or, if desired, to a lower point. How to measure correctly, please use only fixed measuring tapes. The width measurement for roller blinds is the so-called pin measurement. The pin size is wider than the fabric size, so the fabric will be approx. The 4cm is narrower than the ordered roller blind width. The maximum depth of the window frame must not exceed 2cm and not be less than 1cm without a seal to the total width of the roller blind. The fabric width is approx 4cm narrower than the indicated total width. If the roller blind shutters, hooks when pulling down, please check whether you are pointing the mouth, the open part of the head of the chain hoist outwards correctly that the chain blocks. If so, please turn the head of the chain hoist until the open part is covered, then the problem is solved.
