Features

• Quick, easy and convenient to install
• Easy to design and plan your own garden lighting scheme
• Fully interchangeable 'mix and match' range
• Wide choice of styles for all applications
• Important: The Garden Zone Plug and go fittings use a unique single pin, 2 pole plug and as such are not compatible with any other product or system
• Step 4: Plan where the mains supply will originate from. With the plug and go system you have a choice of placing the LED driver/drivers in an IP rated wall box on an exterior wall. However, depending on how large an area is involved, sometimes more than one mains feed may be needed in different locations. Consultation with an electrician is advisable on this matter
• Step 3: Measure the distance involved for the plug and go models chosen and determine, from the cable set options available which cable set or sets will be needed. Remember, up to 50 metres of cable can be used from 1 LED driver but the wattage loading must not exceed the recommended minimum, maximum
• Step 2: Choose the fittings which will suit the requirements and list them out with the quantity of each where relevant. Be careful to bear in mind the voltage of the fittings chosen. All fittings will need mains supply to wherever they are to be installed whereas all plug and go models just need to be connected into the low voltage cable
• Step 1: Choose the areas you want to have lit then sketch a rough plan view of each area involved