Brabantia Iron Store

Unable to hang Leifheit and other standard ironing boards!

Bought the iron rest on a recommendation what a piece of kit. Tidies the broom cupboard up a treat best buy ever.

Fitted to our utility wall to support Swirl Ironing Board and my steam iron. Put board on upside down to have room for iron and flex, no problem though. I can fold flex around holder, bit fiddly at plug end, but practice will make perfect. Good quality and colour. Looks smart as well being extremely neat and useful.

Our Brabentia ironing board is approximately 1.560mm to the underside of the "hooks". This means that due to the length of the chrome legs on the holder, it made it impossible for either of us to place, or remove the iron from the holder, due to the height of the holder from the floor. In my case I was fortunate enough to be in a position to cut some 70mm of each leg and reform the ends to 90 degrees to allow insertion into the rear of the PVC holder, as the original longer legs did. This at least made it a little easier for us both lift out and subsequently relocate the iron as necessary. I fully realise that the holder has been made to allow all model boards to be used, however, all I can say is that on the continent folk must be a lot taller than the average person in England? I have marked the box, re" Would you recommend this product to a friend" with a yes, because the holder is well made and value for money. BUT please bear in mind my comments.

The product is fine. However when I add my Brabatina ironing board and iron to the unit it will not fit my cellar door which is 79 inches/200cms tall. Please could you make the height and clearance height are exact.